Aqua-pure Complete User Manual download pdf (Page 5)

1. Turnoffcoldwatersupplyvalveandremoveexistingwater

supplytubingand/ortting.

2. Selectandmarkalocationunderthesinkthatallowsac-

cessforlterchange.

3. Usinglterhead/bracketasaguide,fastenFilterHeadAs-

sembly to wall with #2 Phillips mounting screws supplied.

 Markholelocationssothatthereis11/2”betweenthe

screws(seeFigure1),fromcenterofeachscrew.When

installed,lterbottomshouldbeatleast21/2”fromsink

cabinetoortofacilitatecartridgechange.Installscrews,

butonlyhalfway,soyoucaneasilyslipthebrackettowall

beforermlysettingscrews.

4. Determinelengthoftubingrequiredfromlterhead/

brackettofaucetandfromwatersupplylinetolter

head/bracketbyholdingtubinginplaceensuringitisof

appropriatelength.Donotkinktubingasthiswillimpede

waterow.Ifnecessary,looptubingaroundtoavoidit

beingkinked.

 Cuttubingstraightwithautilityknife.(SeeFigure2).

5. Locate the cold water stem on the underside of the faucet

xture.Unscrewthecoldwaterfeedtubefromthefaucet

stem. Locate the 1/4” Feedwater Adapter that came with

yourDrinkingWaterSystem.Inserttheblackgasketinto

thethreadedadapterandtightenontotheFaucetColdWater

Stemunderthesink,makingsurethat1/4”ttingisacces-

sibleandnotfacingthewall.Makesurenottoovertighten.

 TaketheColdWaterFeedTubeandattachtotheFaucet

Adapter,makingsurenottoovertighten.

Locate the 1/4” Blue Tubing and insert into the 1/4” Faucet

Adapter(Figure3).See“UsingPush-InFittings.”

INSTALLATION INSTRUCTIONS

Correct Incorrect

Figure 2

Figure 1

For Use With Cold Water Only.

NOTE:Removeitemsfromunderthesink.Placecatchbasintheretocollectsmallamountsofwaterthatmayrunout

when disconnecting water supply lines.

Figure 3

Blue Tubing

Faucet Stem

Undersink

Feedwater

Tube

To Release Tubing

Push in grey collet to release tubing. With collet

held, pull tubing straight out.

Collet

Backstop

“Using Push-In Fittings”

To Attach Tubing

Push tubing in as far as it will go. Tubing must be inserted past

o-ring and hit backstop. Pull tube to ensure it is secured.

CAUTION

To reduce the risk associated with property damage due to water leakage:

 • Ensurealltubingandttingsaresecureandfreeofleaks.

1 2 3 4 5 6 ... 20

Comments to this Manuals

No comments

Aqua-pure Complete User Manual Page 5

Comments to this Manuals

Related products and manuals for Water equipment Aqua-pure Complete