Aqua-pure SS20 EPE-316L User Manual download pdf (Page 4)

HEIGHT REQUIRED TO

CHANGE CARTRIDGE

Elevation View

(See Plan View for True Orientation)

HAND KNOB

COVER

PRESSURE PLATE ASSEMBL

COVER GASKET

V-BAND CLAMP

CARTRIDGE POSTS

DRAIN PLUG 3/4" NPT

(SLUDGE DRAIN)

CARTRIDGE

PEDESTA

FLOW

BAFFLE

CENTER

ROD

1/4" NPT

VENT PLUG

DIRTY DRAIN

ABOVE CLEAN DRAIN

3/4" NPT

Plan View

LTUO

T-BOLT

SS4-316L, SS8-316L, SS12-316L and SS20-316L Filter Housing Series

Installation

1)Installing the Filter Housing (SS4-316L, SS8-316L, SS12-316L and SS20-316L Filter Housing Series)

The ﬁ lter housing should be placed on 8” (20 cm) cinder or cement blocks to permit ease of draining. Locate the inlet (marked as “IN” and

Outlet (marked as “OUT”) connections on the housing cylinder. Connect the water supply line piping to the Inlet connection and the ﬁ ltered

water piping serving the building to the Outlet connection. Shut off valves are to be installed on each side of the housing (See note). DO

NOT install the ﬁ lter housing backwards by connecting the water supply line piping to the Outlet. The drain plugs should then be removed

and either a drain line assembly (with two valves) or two hose bibs (faucets) should be installed. See Figure 1 for proper installation. Install

ﬁ lter cartridges per Step 2 prior to ﬁ lter housing start-up.

Note: When the housing is installed in close proximity to the water metere or pressure tank, the main shut off valve may be used for the

Inlet water control valve.

Note: Installation must comply with state and local plumbing codes.

1 2 3 4 5 6 7 8

No comments

Aqua-pure SS20 EPE-316L User Manual Page 4